Find answers, ask questions, and connect with our community here!

Activity Feed Forums General Door Jamb Issue

  • Door Jamb Issue

    Posted by Gerald on October 21, 2021 at 3:42 pm

    I’m using Adura Max 12 X 24 and had to do a door jamb wrap, in doing so I had to cut off a section to wrap around the jamb. The 1/2 copper pipe created the obstacle. What is the best way to connect that stub piece at the end? Glue a small piece to the last row and deal with the oddball seam? Thanks

    Joe replied 1 year, 11 months ago 2 Members · 4 Replies
  • 4 Replies
  • Joe

    October 21, 2021 at 4:05 pm

    Yes, that is what i would do!

  • Gerald

    October 21, 2021 at 7:46 pm

    Thanks Joe – it is in an inconspicuous place and at the end of the floor near the area where the stair nose is going to go. The Adura is so rigid that what I did may have been my only option. Wrapping around door jambs can be challenging. Did you ever use a thin sheet of aluminum and glue the back to hold the pieces together, but not gluing to the floor itself. I have some very thin coil stock.

  • Joe

    October 22, 2021 at 8:56 am

    I would only glue it in the joint and it will stay put.

  • Joe

    October 22, 2021 at 12:11 pm