Find answers, ask questions, and connect with our community here!

  • Blueprint Request please

  • Lore

    Member
    September 19, 2021 at 4:13 pm

    Joe, great website, and thanks for all that you are doing.

    I have attached drawings (ppt and pdf) for a Blueprint Request. Not sure where to start. As you look at the floor plan entering the front door, there is a long hallway-like area from the foyer to the back of the living room as you just enter the front door (runs South to North). There is another hallway that runs from the guest bedroom to the dining room (East to West). Finally, there’s another long hallway from the Garage door entrance that runs to the dining room (North to South). All are relatively long and open. Using Lifeproof LVP, 9″ X 48″. I put a sample drawing of it on the lower right-hand corner of the floor plan. All the areas with the highlighted Gray text will not get LVP (already tiled wet areas or outside. I intend to minimize transitions as much as possible. Thanks again for all your assistance.

    Lore

  • Joe

    Administrator
    September 20, 2021 at 11:53 am

    Watch this Lore – http://somup.com/crQYDsrG2f

    • Lore

      Member
      September 20, 2021 at 2:57 pm

      Joe, thanks for the tremendous insight, and thanks for the quick turnaround and response. You’re awesome. I have decided to run the planks from North to South (as you have suggested), starting from the left side of the island as shown on the diagram and as recommended by you. Looking forward to the blueprint. I have already recommended your website to a few friends who are interested in re-doing their floors. I have watched most of your videos, and you are able to make this process very understandable. May God bless you and your family.

      -Lore

  • Joe

    Administrator
    September 20, 2021 at 3:04 pm

    Thank you!! I will get this to you tomorrow.

  • Joe

    Administrator
    September 21, 2021 at 4:22 pm

    HERE IS YOUR BLUEPRINT – http://somup.com/crQrr3rHyH

Viewing 1 - 4 of 4 replies

Original Post
0 of 0 posts June 2018
Now